The DT-1 frame dimpling tool is designed to aid in hollow metal door frame installation by adding a recess when “field-dimpling” a frame. Examples of use would be installing a new metal frame in an existing masonry or stud opening. The DT-1 is hardened & uses an allen screw & wrench to smoothly add a dimple to the door frame after it has been drilled. Once the dimple is in place a lag or toggle bolt will fit flush to the edge of the frame.
Typically, a frame is “punched & dimpled” three to four times on each side of the door frame. The DT-1 makes the job an easy one with a professional looking fit to the fasteners.
The tool is double-sided; after extensive use some wear may be evident in the threads or face of the tool; simply use the opposite side. Two allen screws and a long-arm allen wrench are also included.
When you need to field-punch & dimple a frame, you know what a time consuming mess the old "ball peen hammer" method can be. Bowed frames and fasteners sticking out scream "poor installation" to your customer. The Framon DT-1 Frame Dimpling tool makes your installations look professional, but the biggest plus is the time it saves. Once you drill the holes, simply place the DT-1 on the inside of the frame and screw the hardened allen screw into the tool. The angled screw head leaves a perfect dimple every time. As shown above, the tool comes with an allen wrench, but make the job even quicker by using an impact drill to drive the screw in. Using an impact drill, a frame with six dimples can be finished in about 90 seconds. This tool is hardened, and uses standard 3/8-24 x 1" screws, that are not hardened, so they wear out, and not your tool.
